741 ic

Overvoltage Protection AutoCut OFF Using 741

Share this

High voltage Protection circuit

overvoltage protection cutoff circuit diagram using 741 opamp

This is a High voltage Protection circuit that Protects the circuit from high voltage to any device by the automatic cutoff using the popular ic 741.

Note- Connect the load with the NC pin of the relay

When the input voltage at Non- the non-inverting pin of op-amp 741 is crossed over the set reference voltage. The output of this ic at pin 6 is going to High and the relay is activated and then changed the relay pin from NC (normally connected) to NO (normally open). The appliance gets disconnected  And a Reference voltage is given through the Zener diode to fix a level.

VCC terminal pin 7 of comparator 741 is connected through the regulator ic 7812 to provide the fixed supply. But the input signal at pin 3 and pin 4 is given before regulated ic to detect the fluctuation of supply. Pin 4 is connected with the negative supply. Give 12v DC to this circuit.

At first, if the input supply voltage in the circuit is below and under the required level then the output of ic 741 is LOW, and the connected transistor remains to turn off and the relay is not activated. Appliances are On. Connect the load with NC.

As the input supply increases then the voltage at pin 3 also increases, and when the value of the voltage at pin 3 is greater than pin 2, then the output voltage of 741 goes High, and now the relay is activated and the supply is disconnected.

Autocut off level is set by adjusting the prest by moving it. And after adjusting the cutoff level this circuit is used to sense the adjusted maximum input voltage level. This circuit is useful to the protection of any appliance by the High voltage supply. In this circuit, one 741 ic is used as a comparator to detect and compare the input signal with respect to a reference voltage. The reference voltage (Vref) is the voltage, with the level of input signal we want to compare. In this circuit Reference voltage is given at the inverting terminal by the Zener diode to fix the constant level to make sense. This circuit can be used AC or DC Load But this circuit needs only DC.

Input voltage (At Pin 4) < Reference Voltage (At Pin 2) – Then Output at Pin 6 is High and vice-versa.

Pin of 7812 (Front view)


Pin 1= input (Line voltage),  Pin2= Ground (Common),  Pin 3= VREG(Out)


IC 741-1

Preset- 50K-1





Zener Diode 6.8v (1W)-1

Transistor- BC547-1


Relay 12v-1

Diode 1N4007-5


0.1uf – 1

1000uf- 1

Transformer 12v(12-0-12v)

Also read

Share this

8 thoughts on “Overvoltage Protection AutoCut OFF Using 741”

  1. For the over voltage protection circuit using 547 tr for long life of tr go for CL100 or BC 108 . Provide a cap 100 mfd 63v parallel to the relay coil.during activation of the relay high ac pulses can occur parallel to rly coil so I reccoment 100mfd 63v cap this will also reduce the relay chattering. For back emf bypass provide in4007 diode cathode of the diode on collector and anode tothe emitter of the transistor.

        1. Hi
          Please i try build this over voltage circuit it works but if voltage be come high the relay will be making gregree sound be fr cut off guide me please thank God bless.

  2. High sir please how can l design a voltage current regulator circuit. I want to regulate both the voltage and the current.

Leave a Comment

Your email address will not be published. Required fields are marked *